
139-0498-01.66
Chapter One--Overview
Controller overview Figure 1–1 shows the parts of the RPC controller.
A brief description of each part follows in Table
1–1.
Figure 1-1: RPC Controller
A
B
C
D
E
F
G
H
I
J
K
L
M
N
OPQ
R
STUV
A. O Button (Red)
B. On Button (Green)
C. LCD Screen
D. DMX Input and Thru
E. RS-232 Port
F. Ethernet Port
G. Menu Up Button
H. Menu Down Button
I. Analog Inputs
J. AST Input
K. Audio Signal Indicator
L. AST Sensitivity Potentiometer
M. Auxiliary Power Output
N. Reset Button
O. MPE Board Port
P. I/O Board Port
Q. Power LED
R. Power Supply Input
S. CPU LED
T. Right RX LED
U. Right Control Bus Port
V. Right TX LED
W. Left RX LED
X. Left Control Bus Port
Y. Left TX LED
Z. Digital I/O Ports
Table 1-1: Parts of the RPC Controller
Component Description
A. OFF Button Turns all breakers o
B. ON Button Turns all breakers on
C. LCD Screen Screen shows the IP address, time and setup information.
D. DMX Input and Thru Allow the panel to be directed by a secondary DMX controller. When DMX is enabled, the
control page is disabled.
E. RS-232 Port Control Port for secondary controller such as AMX or Crestron.
F. Ethernet Port Connects the panel to a computer or network for initial setup or long-term operation us-
ing the built-in web interface.
G. Menu Up Button (yellow) Scrolls the screen up.
H. Menu Down Button (yel-
low)
Scrolls the screen down.
I. Analog Inputs Additional analog inputs to connect voltage/current monitors or light sensors.
J. AST Input Connects to the Audio Sensing Timer
K. Audio Signal Indicator Flashes when audio signal is present.
L. AST Sensitivity Pot Sets the sensitivity of the Audio Sensing Timer
M. Auxiliary Power Output Auxiliary 24V power for accessories.
Controller Overview
WXY
V
E
TCP/IP
Network
connect
Z
Kommentare zu diesen Handbüchern