Lyntec RPC Bedienungsanleitung PDF herunterladen (Seite 43)

139-0498-01.43 43

Appendix A

6

Conﬁ gure the digital I/O port.

Note: If the Emergency Shutoff

feature is selected, the ﬁ rst

position in the Onboard ﬁ eld (on

the Controller) is automatically

assigned to that.

A. Rename each contact closure as

desired

B. Click the M (merge) button at

the right side of the ﬁ rst of the

two ports used. The name box

and M button in the second port

should turn gray and the Action

selections should default to

Momentary NO. (normally open)

C. Ensure that both of the Action

selections for both ports are set

to Momentary NO.

D. Click the “Save Changes” button

at the top of the Onboard I/O

box.

7

Assign the contact closure to a zone

in the “Panel” (SETUP==>PANELS)

screen:

A. In the ZONE CONTROL box under

“CC/Schedule”, choose which

contact closure to assign to any

zone using the drop down box.

B. Enable the zone by selecting

Sequenced or Grouped operation

under “Name/Seq”.

C. Save changes.

8

Verify proper operation of your

Switch Set:

A. Press the ON switch. Breakers in

the selected zone should immedi-

ately begin actuating.

B. The ON indicator should ﬂ ash

steadily until all of the breakers

are in the on state.

C. When the zone has completed,

the ON indicator should remain

constantly lit.

D. Press the OFF switch. Breakers in

the selected zone should immedi-

ately begin actuating.

E. The ON indicator should ﬂ ash

steadily until all of the breakers

are in the off state.

F. When the zone has completed,

the ON indicator should remain

constantly dark. Note: When

using two illuminate pushbut-

tons the OFF indicator will remain

constantly lit when the zone has

completed. (OFF indicator will

extinguish immediately when ON

is pressed again.)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 56 57

Kommentare zu diesen Handbüchern

Keine Kommentare