Lyntec RPC Bedienungsanleitung PDF herunterladen (Seite 13)

139-0498-01.13 13

Chapter Four--Wiring

2. At the RPS Slave panels, strip the cable sheath back

approximately 20 inches. Cut the conductors for Left Bus

B, Left Bus A, – and + down to approximately 4 inches and

terminate them in the Left Bus screw-terminal header from

left to right. Terminate the remaining two conductors in

the Right Bus B and Right Bus A positions of the Right Bus

screw-terminal header.

3. Using two cut lengths of 18 AWG wire, install jumpers from

Left Bus – and + to Right Bus – and +. Right Bus will not

operate without these jumpers installed to provide 24VDC

power and common.

4. Set the slave address selectors as follows:

Table 4-2

Left Control Bus Right Control Bus

Panel #2 2 3

Panel #3 4 5

Panel #4 6 7

Master Panel

Slave Panel 2 Slave Panel 3 Slave Panel 4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

Keine Kommentare

Lyntec RPC Bedienungsanleitung Seite 13